Aktualności

18.04.2017
Vacuum brazing: Good to know - a short overview

Vacuum brazing enables development engineers and production persons in charge to design and manufacture parts in a modular way. Starting with simple pre-products complex shaped parts can be realized cost-effectively and/or with minimized effort for pre- and post-machining.

więcej >> 18.04.2017
Vacuum brazing: Good to know – production and reparation of gas turbine components by vacuum brazing

Flying and land-based gas turbine components are heavily loaded and quite expensive. For this reason maintenance of turbine components is an important contribution to conserving resources and cost savings.

więcej >> 18.04.2017
Vacuum brazing: Good to know - vacuum brazing in mechanical and apparatus engineering

The shown hot water components are a typical example for a material efficient modular design. Components are assembled out of simple, well available pre-fabricates, which then are brazed to each other.

więcej >> 18.04.2017
Vacuum brazing: Good to know - reducing unit costs of plastic injection moulded parts

Producer of plastic injection moulded parts have the permanent challenge to reduce unit costs and to raise component quality. A conformal cooling of moulds and dies reduces cycle times and significantly improves dimensional stability of the plastic parts.

więcej >> 27.10.2016
Racing Season GreenTeam

The student race team GreenTeam of the University of Stuttgart looks back to a sucessful racing season 2015/2016. With the actual, electrical driven ...

więcej >>

« początek« poprzednia1 2 3 4 5 6następna »ostatnia »